Bootmod3 adapter BM3 ENET CANBUS OBD wireless

With its small form factor, great connectivity characteristics, ability to switch from a WiFi to a Wired connection without having to do a battery reset (unlike generic adapters today), wireless connectivity to CAN where needed, ability to leave it plugged in full time and turn it off and not set of the car’s alarm when left plugged in (G series/Supra issue) are just some of the reasons why we feel this adapter takes connectivity and overall ease of use to the next level.

This unit is made to replace the generic ENET adapter some have been using already. They have served BM3 users well but in many cases have also been causing various headaches with connectivity. We can’t count the number of times we had left them plugged in, walked away from the car, and 10 seconds later had alarms go off only to walk back to get them unplugged (G series/Supra vehicles).

Features:

• Fastest flash times over ENET and CANBUS
• Reliable and consistent connectivity
• Wireless ENET support for BMW F and G series vehicles and 2020+ Toyota Supra
• Wireless CANBUS Support
  • Unlike generic WiFi adapters, our adapter allows full flashing of transmission on GEN2 BMW and 2020+ Toyota Supra removing need for additional WiFi adapters or DCAN cables
• V3 Version ONLY - NO ALARMS if left plugged in (BMW G series vehicles and Toyota Supra)
  • Enters ultra low power mode if left plugged in consuming just ~20mA
• OTA updates through the new bootmod3 app
• Firmware fully extensible for additional flash and diagnostic protocols for future connectivity support
• V2A version of the adapter will trigger alarm on G series vehicles and 2020+ Toyota Supra. It is a lower cost option for those that don't mind unplugging their adapter after use
• Manual Toggle switch to fully power down adapter
• Small form factor, considerably smaller than generic WiFi ENET adapters
• No VIN locking, can be used on multiple vehicles